How to Onboard Your AirDoctor to the App – AirDoctor

Please follow the steps below to onboard the AirDoctor app for WiFi-enabled models including AD2000i Smart, AD3500i Smart, and AD5500i Smart.

iOS:

Open the AirDoctor app and create your account.
Once you have created an account, Select ‘Add New Device
Press and hold the Wifi button on the control panel until the light begins blinking. This indicates the device is in Discovery Mode
Select ‘Create Room’ and create a room, then the app will start searching for your AirDoctor.
1. You can create a room by name to indicate where you’ll run your AirDoctor. This is useful if you have or plan to use more than one AirDoctor.
2. You may have to hold the down the Wifi button again to put the AirDoctor in Discovery Mode
Select your unit when recognized in the app. (The name will be a mix of numbers and letters. You can rename the device later in the settings.)
Confirm your WiFi network
Enter your WiFi password
Wait for pairing confirmation. This may take a few minutes.
When connected successfully, the WiFi light will turn solid blue.
To receive alerts about your air quality and filter life be sure to activate Notifications.